HomeAll calculatorsBack

gravel calculator for road

Calculation Formula:

Vcompacted = Σ(L × W × d)
Vloose = k × Vcompacted
M = Vloose × ρloose OR Vcompacted × ρcompacted

ft, ft, in (US); m, m, mm (metric)
ratio
short tons/yd³ (US) / kg/m³ (metric)

Choose the relevant mode and complete its visible inputs using the specified units. Optional density may be left blank for a volume-only estimate.

1. What Does This Tool Calculate?

gravel calculator for road: Estimate compacted road/base volume and mass using density in the matching state.

Choose the measurement method that matches your task, and use the input units shown for that mode.

2. Formula and Worked Example

Vcompacted = Σ(L × W × d)
Vloose = k × Vcompacted
M = Vloose × ρloose OR Vcompacted × ρcompacted

Use the values in the units shown. The displayed equation converts the entered inputs into the labeled results; no unlisted product factor is applied.

Example: A compacted 10 ft × 12 ft × 3 in section has 1.11 yd³ volume. k = 1.2 gives 1.33 yd³ loose; density 1.4 short tons/yd³ then gives 1.87 short tons.

3. Planning Your Calculation

k means loose volume per compacted volume. Do not apply an allowance twice or mix loose volume with compacted density. Loose volume is not derived in compacted-density mode.

4. Using the Calculator

  1. Choose unit system.
  2. Enter one compacted section per line: length, width, depth in ft, ft, in (US); m, m, mm (metric).
  3. Choose density basis.
  4. Enter loose volume per compacted volume in ratio.
  5. Enter bulk density in selected state in short tons/yd³ (US) / kg/m³ (metric).
  6. Click Calculate, then click the image on the next page to view your results.
  7. Review the units and assumptions before using the estimate.

5. Frequently Asked Questions

What values do I need?
Enter unit system, one compacted section per line: length, width, depth, density basis, loose volume per compacted volume, bulk density in selected state.

What units does this tool use?
Input units: ft, ft, in (US); m, m, mm (metric), ratio, short tons/yd³ (US) / kg/m³ (metric). Results show their own units. Do not mix unit systems.

Which assumptions matter?
k means loose volume per compacted volume. Do not apply an allowance twice or mix loose volume with compacted density. Loose volume is not derived in compacted-density mode.

Where do my results appear?
Submit the form to the confirmation page, then click its image. The result page restores your entries and displays the calculation. Saved entries are available in the same browser for 30 minutes.

Can I change the entries?
Yes. Edit the form on the result page and calculate again. Each submission has a separate result link.

gravel calculator for road © 2026