Calculation Formula:
rip rap calculator with slope: Estimate a uniform riprap layer on a planar slope using its sloping surface length.
Choose the measurement method that matches your task, and use the input units shown for that mode.
Use the values in the units shown. The displayed equation converts the entered inputs into the labeled results; no unlisted product factor is applied.
Example: A horizontal run of 10 ft and rise of 3 ft give a sloping length of 10.44 ft. At 12 ft width and 3 in perpendicular thickness, volume is about 31.32 ft³.
Depth is measured perpendicular to the slope surface. This is a quantity estimate; it does not determine rock size or slope stability.
What values do I need?
Enter slope run measured horizontally, vertical rise, area width, installed depth, supplier bulk density.
What units does this tool use?
Input units: ft, in, US short tons/yd³. Results show their own units. Do not mix unit systems.
Which assumptions matter?
Depth is measured perpendicular to the slope surface. This is a quantity estimate; it does not determine rock size or slope stability.
Where do my results appear?
Submit the form to the confirmation page, then click its image. The result page restores your entries and displays the calculation. Saved entries are available in the same browser for 30 minutes.
Can I change the entries?
Yes. Edit the form on the result page and calculate again. Each submission has a separate result link.