HomeAll calculatorsBack

riprap apron calculator

Calculation Formula:

D₅₀ = 0.2D × [Q ÷ (√g × D5/2)]4/3 × D/TW
V ≈ L × (W₁ + W₂) ÷ 2 × Thickness

m
m³/s
m
m
m
m
m

Choose the relevant mode and complete its visible inputs using the specified units. Optional density may be left blank for a volume-only estimate.

1. What Does This Tool Calculate?

riprap apron calculator: Evaluate the supplied HEC-14 round-pipe outlet equation and apron quantity.

Choose the measurement method that matches your task, and use the input units shown for that mode.

2. Formula and Worked Example

D₅₀ = 0.2D × [Q ÷ (√g × D5/2)]4/3 × D/TW
V ≈ L × (W₁ + W₂) ÷ 2 × Thickness

Use the values in the units shown. The displayed equation converts the entered inputs into the labeled results; no unlisted product factor is applied.

Example: For D = 1 m, Q = 2 m³/s and TW = 0.6 m, evaluate the sizing equation. A 5 m apron widening from 2 m to 4 m at 0.5 m thickness needs 7.5 m³.

3. Planning Your Calculation

Use consistent SI units and TW between 0.4D and 1.0D; out-of-range inputs are rejected. Obtain length and thickness from the applicable design tables. This outlet method is not a general river/bridge method.

4. Using the Calculator

  1. Enter round outlet pipe diameter d in m.
  2. Enter outlet discharge q in m³/s.
  3. Enter tailwater depth tw in m.
  4. Enter designed apron length in m.
  5. Enter designed upstream apron width in m.
  6. Enter designed downstream apron width in m.
  7. Enter designed layer thickness in m.
  8. Click Calculate, then click the image on the next page to view your results.
  9. Review the units and assumptions before using the estimate.

5. Frequently Asked Questions

What values do I need?
Enter round outlet pipe diameter d, outlet discharge q, tailwater depth tw, designed apron length, designed upstream apron width, designed downstream apron width, designed layer thickness.

What units does this tool use?
Input units: m, m³/s. Results show their own units. Do not mix unit systems.

Which assumptions matter?
Use consistent SI units and TW between 0.4D and 1.0D; out-of-range inputs are rejected. Obtain length and thickness from the applicable design tables. This outlet method is not a general river/bridge method.

Where do my results appear?
Submit the form to the confirmation page, then click its image. The result page restores your entries and displays the calculation. Saved entries are available in the same browser for 30 minutes.

Can I change the entries?
Yes. Edit the form on the result page and calculate again. Each submission has a separate result link.

riprap apron calculator © 2026