Calculation Formula:
hec-ras riprap calculator: Evaluate the supplied Maynord riprap sizing equation.
Choose the measurement method that matches your task, and use the input units shown for that mode.
Use the values in the units shown. The displayed equation converts the entered inputs into the labeled results; no unlisted product factor is applied.
Example: For D = 2 m, U = 2 m/s, γw = 9.81 and γs = 26 kN/m³, SF = 1.1, Cs = 0.3 and K1 = Cv = CT = 1, use the equation to obtain the preliminary d30. These are illustrative inputs.
Take coefficients from the applicable engineering manual. Depth and velocity must describe the corresponding bed or bank. Check gradation and scour separately. This mode uses SI units with g = 9.80665 m/s².
What values do I need?
Enter corresponding bed/bank water depth d, corresponding local velocity u, water unit weight γw, stone unit weight γs, slope correction k1, safety factor sf, stability coefficient cs, velocity-distribution coefficient cv, layer-thickness coefficient ct.
What units does this tool use?
Input units: m, m/s, kN/m³, ratio. Results show their own units. Do not mix unit systems.
Which assumptions matter?
Take coefficients from the applicable engineering manual. Depth and velocity must describe the corresponding bed or bank. Check gradation and scour separately. This mode uses SI units with g = 9.80665 m/s².
Where do my results appear?
Submit the form to the confirmation page, then click its image. The result page restores your entries and displays the calculation. Saved entries are available in the same browser for 30 minutes.
Can I change the entries?
Yes. Edit the form on the result page and calculate again. Each submission has a separate result link.