HomeAll calculatorsBack

rip rap size calculator

Calculation Formula:

d₃₀ = SF × Cs × Cv × CT × D × [√(γw ÷ (γs − γw)) × U ÷ √(K1 × g × D)]2.5

m
m/s
kN/m³
kN/m³
ratio
ratio
ratio
ratio
ratio

Choose the relevant mode and complete its visible inputs using the specified units. Optional density may be left blank for a volume-only estimate.

1. What Does This Tool Calculate?

rip rap size calculator: Evaluate the supplied Maynord riprap sizing equation.

Choose the measurement method that matches your task, and use the input units shown for that mode.

2. Formula and Worked Example

d₃₀ = SF × Cs × Cv × CT × D × [√(γw ÷ (γs − γw)) × U ÷ √(K1 × g × D)]2.5

Use the values in the units shown. The displayed equation converts the entered inputs into the labeled results; no unlisted product factor is applied.

Example: For D = 2 m, U = 2 m/s, γw = 9.81 and γs = 26 kN/m³, SF = 1.1, Cs = 0.3 and K1 = Cv = CT = 1, use the equation to obtain the preliminary d30. These are illustrative inputs.

3. Planning Your Calculation

Take coefficients from the applicable engineering manual. Depth and velocity must describe the corresponding bed or bank. Check gradation and scour separately. This mode uses SI units with g = 9.80665 m/s².

4. Using the Calculator

  1. Enter corresponding bed/bank water depth d in m.
  2. Enter corresponding local velocity u in m/s.
  3. Enter water unit weight γw in kN/m³.
  4. Enter stone unit weight γs in kN/m³.
  5. Enter slope correction k1 in ratio.
  6. Enter safety factor sf in ratio.
  7. Enter stability coefficient cs in ratio.
  8. Enter velocity-distribution coefficient cv in ratio.
  9. Enter layer-thickness coefficient ct in ratio.
  10. Click Calculate, then click the image on the next page to view your results.
  11. Review the units and assumptions before using the estimate.

5. Frequently Asked Questions

What values do I need?
Enter corresponding bed/bank water depth d, corresponding local velocity u, water unit weight γw, stone unit weight γs, slope correction k1, safety factor sf, stability coefficient cs, velocity-distribution coefficient cv, layer-thickness coefficient ct.

What units does this tool use?
Input units: m, m/s, kN/m³, ratio. Results show their own units. Do not mix unit systems.

Which assumptions matter?
Take coefficients from the applicable engineering manual. Depth and velocity must describe the corresponding bed or bank. Check gradation and scour separately. This mode uses SI units with g = 9.80665 m/s².

Where do my results appear?
Submit the form to the confirmation page, then click its image. The result page restores your entries and displays the calculation. Saved entries are available in the same browser for 30 minutes.

Can I change the entries?
Yes. Edit the form on the result page and calculate again. Each submission has a separate result link.

rip rap size calculator © 2026